Assembly step 1

From ShapeOko
Revision as of 16:11, 7 June 2012 by Edward (Talk | contribs) (added BoM)

Jump to: navigation, search
(click the picture to download the PDF file)

Wheel Assemblies

When assembling the wheels, remember to place the precision washers (1mm thick) between the bearings. The precision washers are exactly 1mm thick and provide a surface for the races to contact, keeping everything tight.


V-Wheel Assembly:

  • Insert a bearing into one side. These are force fit tolerances so you might have to push hard.
  • Press the bearing until it's seated against the inside lip of the v-wheel.
  • Slide an M5 bolt through the bearing (outside in) - you'll use this to align the precision washer and the other bearing.
  • Slide the precision washer over the bolt and let it slide all the way down until it is touching the bearing you just inserted
  • Slide the other bearing over the bolt and let it slide down until it hits the rim of the v-wheel.
  • Press the second bearing into the v-wheel just as you did the first
  • When the assembly is complete, you can remove the M5 bolt

Note: do not forget the precision washer!

Bill of Materials

1 1 MSK01-05 V Wheel
2 2 MSK01-07 5mm x 16mm x 5mm bearing
3 1 MSK01-08 Precision Washer (1mm thick)

User Submitted Notes

(This is the section to add your own notes pertaining to this sub-assembly) If you run into a problem or find yourself asking a question, please post the solution here to help the next person who has the same problem/question)