Assembly step 11

From ShapeOko
Revision as of 13:37, 23 November 2012 by Glennpowers (Talk | contribs) (Added Next Link)

Jump to: navigation, search
(click the picture to download the PDF file)

Bill of Material

Sortable table
Item Qty. Part Num. Title
1 2 MKS01-02 MakerSlide 375mm
2 1 Front/Back Panel Front/Back Panel (see above diagram)
3 5 SM-H07 M5 x 10mm SHCS
4 5 SM-H03 M5 Flat Washer
5 1 SM-M05 Belt Anchor
6 1 SM-H11 Insertion Nut

User Submitted Notes

(This is the section to add your own notes pertaining to this sub-assembly) If you run into a problem or find yourself asking a question, please post the solution here to help the next person who has the same problem/question)

Don't tighten the screws completely at this step, but rather after all the frame has been assembled.

Just like mentioned above, don't tighten the screws completely at this step; leave them loose. It also helps if you can slide the screws from side to side in the slots (this may require you to cut out some paint with a razor blade or other tool). This will help in squaring up the whole assembly towards the end of the build.

It's easier to insert the makerslide into the Y axis plates before you put the end plate on. As an alternative to steps 11 and 12: 1) open up the vwheel spacing (rotate the eccentric nuts so the top/bottom wheels are far apart). 2) Insert the makerslide lengths into the wheels. 3) Position the entire gantry assembly close to the edge of your workbench with the makerslide overhanging the edge of the bench. 4) Bolt end-plate on.

Next: Assembly step 12