Difference between revisions of "Assembly step 14"

From ShapeOko
Jump to: navigation, search
(Wire your motors)
 
(18 intermediate revisions by 8 users not shown)
Line 1: Line 1:
Connecting your Electronics:
+
These are the instructions for the SO1 and are here for historical reasons only.
  
==Wire your motors==
+
If you are building an SO2, please see the instructions at http://docs.shapeoko.com/
* Strip ends of wires
+
* Splice on an extra foot of stepper cable to your X and Z axis motor leads (use the screw down terminals)
+
* Crimp your connectors onto the end of the cables.
+
  
If you're unfamiliar with crimping the .1" molex connectors and/or don't have the proper crimper. Here's a video from nophead (of reprap fame) showing how to complete this step with just a pair of needle-nose pliers.
+
==Overview==
{{#ev:youtube|KEm2PuHBt4Y}}
+
  
==Power Supply==
+
Due to minor design modifications, each batch from Inventables varies slightly from the last. To view the information most relevant to your build, select the appropriate batch number below:
{|
+
 
| [[File:Psc13end.Jpg|left|thumb|300px|(c13 end of power supply)]]  
+
*[[Kickstarter_Electronics|Kickstart Electronics]]: July 2011
| [[File:Psminifitend.Jpg|left|thumb|300px|(end of power supply with 6 pin mini-fit)]]
+
*[[PreInventables_Electronics|Pre-Inventables Electronics]]: August 2011 - March 2011
| [[File:4to6pinminifit.jpg|left|thumb|300px|(6pin mini-fit to 4pin molex)]]
+
*[[Inventables_Electronics_Batch_1|Inventables Batch #1 Electronics]]
|}
+
*[[Inventables_Electronics_Batch_2|Inventables Batch #2 Electronics]]
 +
*[[Inventables_Electronics_Batch_3|Inventables Batch #3 Electronics]]
 +
*[[Inventables_Electronics_Batch_4_and_5|Inventables Batch #4 & #5 (current) Electronics]]  
 +
 
 +
If you are sourcing your own, refer to the [[Electronics]] and [[Advanced Electronics]] pages.
 +
 
 +
=== Next: [[Assembly step 15]] ===

Latest revision as of 20:50, 19 May 2014

These are the instructions for the SO1 and are here for historical reasons only.

If you are building an SO2, please see the instructions at http://docs.shapeoko.com/

Overview

Due to minor design modifications, each batch from Inventables varies slightly from the last. To view the information most relevant to your build, select the appropriate batch number below:

If you are sourcing your own, refer to the Electronics and Advanced Electronics pages.

Next: Assembly step 15