Difference between revisions of "Assembly step 14"

From ShapeOko
Jump to: navigation, search
Line 1: Line 1:
 
Connecting your Electronics:
 
Connecting your Electronics:
  
 +
==Inventables Electronics==
 
If you have the inventables electronics, go [[Inventables_Electronics|here]].
 
If you have the inventables electronics, go [[Inventables_Electronics|here]].
  
==Wire your motors==
+
==Other Electronics Set ups==
 
* Strip ends of wires
 
* Strip ends of wires
 
* Splice on an extra foot of stepper cable to your X and Z axis motor leads (use the screw down terminals)
 
* Splice on an extra foot of stepper cable to your X and Z axis motor leads (use the screw down terminals)

Revision as of 16:11, 20 June 2012

Connecting your Electronics:

Inventables Electronics

If you have the inventables electronics, go here.

Other Electronics Set ups

  • Strip ends of wires
  • Splice on an extra foot of stepper cable to your X and Z axis motor leads (use the screw down terminals)
  • Crimp your connectors onto the end of the cables.

If you're unfamiliar with crimping the .1" molex connectors and/or don't have the proper crimper. Here's a video from nophead (of reprap fame) showing how to complete this step with just a pair of needle-nose pliers.

Power Supply

(c13 end of power supply)
(end of power supply with 6 pin mini-fit)
(6pin mini-fit to 4pin molex)