Assembly step 14

Connecting your Electronics:

If you have the inventables electronics, go [Inventables_Electronics here].

Wire your motors

• Strip ends of wires
• Splice on an extra foot of stepper cable to your X and Z axis motor leads (use the screw down terminals)
• Crimp your connectors onto the end of the cables.

If you're unfamiliar with crimping the .1" molex connectors and/or don't have the proper crimper. Here's a video from nophead (of reprap fame) showing how to complete this step with just a pair of needle-nose pliers.

Power Supply

(c13 end of power supply)

(end of power supply with 6 pin mini-fit)

(6pin mini-fit to 4pin molex)