Difference between revisions of "Assembly step 4"

From ShapeOko
Jump to: navigation, search
(Bill of Materials)
(User Submitted Notes)
Line 88: Line 88:
 
==User Submitted Notes==
 
==User Submitted Notes==
 
(This is the section to add your own notes pertaining to this sub-assembly) If you run into a problem or find yourself asking a question, please post the solution here to help the next person who has the same problem/question)
 
(This is the section to add your own notes pertaining to this sub-assembly) If you run into a problem or find yourself asking a question, please post the solution here to help the next person who has the same problem/question)
 +
 +
The blue line on top of the motor should be between the motor and the plate.

Revision as of 10:57, 12 June 2012

(click the picture to download the PDF file)

Instructions

Y-Axis Motor Mount Plate

(This is the other side of the gantry. Pay attention to the hole orientation at the top of the plate.)

Take note of a couple of things:

  • These holes need to be on the left (opposite of the previous sub-assembly). The image shows the correct orientation.
  • Each Bolt that goes through the plate gets a washer on BOTH sides.
  • The smooth idlers get a total of 4 washers per bolt.
    • One on the backside of the plate
    • One on the front side of the plate
    • One on the end of the 1/4" spacer
    • One between the idler and the nut that keeps it all together.

Bill of Materials

Sortable table
Item Qty. Part Num. Title
1 1 MSK01-09 18 Tooth Timing Pulley
2 1 SM-S01 Mounting Plate
3 6 SM-H04 M5 Hex Nut
4 2 SM-H01 1/4" Nylon Spacer
6 6 SM-H08 M5 x 30mm SHCS
7 2 MSK01-04 Eccentric Nut
9 20 SM-H03 M5 Flat Washer
10 4 SM-H14 M3 x 8mm SHCS
11 4 SM-H15 M3 Flat Washer
12 1 SM-E01 Nema17 Stepper Motor
13 4 MSK01-05A V Wheel Assembly
16 2 MSK01-06A Smooth Idler Assembly

User Submitted Notes

(This is the section to add your own notes pertaining to this sub-assembly) If you run into a problem or find yourself asking a question, please post the solution here to help the next person who has the same problem/question)

The blue line on top of the motor should be between the motor and the plate.