Assembly step 4

From ShapeOko
Revision as of 16:23, 6 June 2012 by Edward (Talk | contribs) (formatted instructions)

Jump to: navigation, search


Y-Axis Motor Mount Plate

(This is the other side of the gantry. Pay attention to the hole orientation at the top of the plate.)

Take note of a couple of things:

  • These holes need to be on the left (opposite of the previous sub-assembly). The image shows the correct orientation.
  • Each Bolt that goes through the plate gets a washer on BOTH sides.
  • The smooth idlers get a total of 4 washers per bolt.
    • One on the backside of the plate
    • One on the front side of the plate
    • One on the end of the 1/4" spacer
    • One between the idler and the nut that keeps it all together.

User Submitted Notes

(This is the section to add your own notes pertaining to this sub-assembly) If you run into a problem or find yourself asking a question, please post the solution here to help the next person who has the same problem/question)