Assembly step 4

From ShapeOko
Revision as of 20:37, 13 June 2012 by Admin (Talk | contribs) (added instructional video)

Jump to: navigation, search
(click the picture to download the PDF file)


Y-Axis Motor Mount Plate

(This is the other side of the gantry. Pay attention to the hole orientation at the top of the plate.)

Before tightening your motor onto the plate, please watch this video.

Take note of a couple of things:

  • These holes need to be on the left (opposite of the previous sub-assembly). The image shows the correct orientation.
  • Each Bolt that goes through the plate gets a washer on BOTH sides.
  • The smooth idlers get a total of 4 washers per bolt.
    • One on the backside of the plate
    • One on the front side of the plate
    • One on the end of the 1/4" spacer
    • One between the idler and the nut that keeps it all together.

Bill of Materials

Sortable table
Item Qty. Part Num. Title
1 1 MSK01-09 18 Tooth Timing Pulley
2 1 SM-S01 Mounting Plate
3 6 SM-H04 M5 Hex Nut
4 2 SM-H01 1/4" Nylon Spacer
6 6 SM-H08 M5 x 30mm SHCS
7 2 MSK01-04 Eccentric Nut
9 20 SM-H03 M5 Flat Washer
10 4 SM-H14 M3 x 8mm SHCS
11 4 SM-H15 M3 Flat Washer
12 1 SM-E01 Nema17 Stepper Motor
13 4 MSK01-05A V Wheel Assembly
16 2 MSK01-06A Smooth Idler Assembly

User Submitted Notes

(This is the section to add your own notes pertaining to this sub-assembly) If you run into a problem or find yourself asking a question, please post the solution here to help the next person who has the same problem/question)

The blue line on top of the motor should be between the motor and the plate.