Assembly step 6
Axis Mount Plate
This is the second part of your pre-assembly.
Assemble this as shown in the drawing:
- Pay attention to the number of washers on each bolt! it's critical.
- Pay attention to the orientation of the plate. The larger holes in the corner (denoted with an arrow) need to be at the bottom (as shown)
- Tighten the non-eccentric vwheels
- Just snug the delrin nut, we'll want to align it with the threaded rod later, then tighten it down
Bill of Materials
|1||1||MSK01-01||Standard Carriage Plate|
|2||1||SM-M08||Delrin lead nut.|
|4||4||SM-H04||M5 Hex Nut|
|6||2||SM-H01||1/4" Nylon Spacer|
|7||16||SM-H03||M5 Flat Washer|
|8||4||SM-H08||M5 x 30mm SHCS|
|9||2||SM-H07||M5 x 10mm SHCS|
|10||4||MSK01-05A||V Wheel Assembly|
User Submitted Notes
(This is the section to add your own notes pertaining to this sub-assembly) If you run into a problem or find yourself asking a question, please post the solution here to help the next person who has the same problem/question)
It is advised to move the M8 rod up and down the delrin nut a few times (e.g. using a drill) to free up the delrin nut before step 9. The delrin nut is too tight to mount the Z axis later on.
Instructables build images