Assembly step 6

From ShapeOko
Revision as of 14:20, 18 November 2012 by NinjaPixel (Talk | contribs) (User Submitted Notes)

Jump to: navigation, search
(click the picture to download the PDF file)


Instructions

Axis Mount Plate

This is the second part of your pre-assembly.

Assemble this as shown in the drawing:

  • Pay attention to the number of washers on each bolt! it's critical.
  • Pay attention to the orientation of the plate. The larger holes in the corner (denoted with an arrow in the PDF) need to be at the bottom (as shown)
  • Tighten the non-eccentric vwheels
  • Just snug the delrin nut, we'll want to align it with the threaded rod later, then tighten it down

Bill of Materials

Sortable table
Item Qty. Part Num. Title
1 1 MSK01-01 Standard Carriage Plate
2 1 SM-M08 Delrin lead nut.
3 2 MSK01-04 Eccentric Nut
4 4 SM-H04 M5 Hex Nut
6 2 SM-H01 1/4" Nylon Spacer
7 16 SM-H03 M5 Flat Washer
8 4 SM-H08 M5 x 30mm SHCS
9 2 SM-H07 M5 x 10mm SHCS
10 4 MSK01-05A V Wheel Assembly

User Submitted Notes

(This is the section to add your own notes pertaining to this sub-assembly) If you run into a problem or find yourself asking a question, please post the solution here to help the next person who has the same problem/question)

It is advised to move the M8 rod up and down the delrin nut a few times (e.g. using a drill) to free up the delrin nut before step 9. The delrin nut is too tight to mount the Z axis later on.

When noting the orientation of the plate, you need to observe not only the larger corner holes (as noted above), but also the holes for the eccentric nuts. The holes for the eccentric nuts are slightly larger to allow the beveled side of the nut to seat into the plate.

Inventables build images

Required parts
Delrin nut, spacer, bolts and washer
V-wheel, spacer and washer detail
Back of z-axis
V-wheel, eccentric spacer and washer detail
Complete z-axis
Run the Delrin nut along the the rod, using a hand drill, before fixing it to the plate.