Assembly step 6
These are the instructions for the SO1 and are here for historical reasons only.
If you are building an SO2, please see the instructions at http://docs.shapeoko.com/
Z-Axis Mount Plate
This is the second part of your pre-assembly for the X/Z-Axis.
Assemble this as shown in the drawing:
- Pay attention to the number of washers on each bolt! it’s critical.
- Pay attention to the orientation of the plate. The larger holes in the corner (denoted with an arrow in the image) need to be at the bottom (as shown)
- Tighten the non-eccentric V-wheels
- Just snug the delrin nut, we’ll want to align it with the threaded rod later, then tighten it down
Bill of Materials
|6||4||SM-H08||M5 x 30mm SHCS|
|8||16||SM-H03||M5 Flat Washer|
|9||4||SM-H04||M5 Hex Nut|
|13||2||SM-H01||1/4" Nylon Spacer|
|17||1||MSK01-01||Standard Carriage Plate|
|18||1||SM-M08||Z-Axis Delrin Lead Nut|
|19||2||SM-H07||M5 x 10mm SHCS|
|Assembly 1||4||MSK01-05A||V-Wheel Assembly||From Assembly step 1|
User Submitted Notes
(This is the section to add your own notes pertaining to this sub-assembly) If you run into a problem or find yourself asking a question, please post the solution here to help the next person who has the same problem/question)
The threaded rod is a cost-saving alternative to Acme screw or some more expensive purpose-built part, which has resulted in quite a bit of discussion and several alternatives. See SM-M08 (M8) Z-Axis Delrin Lead Nut on the Parts page.
Several users have tried different positions for the Delrin nut, w/o noticeable effect.
It is advised to move the M8 rod up and down the delrin nut a few times (e.g. using a drill) to free up the delrin nut before step 9. The delrin nut is too tight to mount the Z axis later on. As an alternative, a M8 tap really works well here, so long as you are careful not to cross-thread.
When noting the orientation of the plate, you need to observe not only the larger corner holes (as noted above), but also the holes for the eccentric nuts. The holes for the eccentric nuts are slightly larger to allow the beveled side of the nut to seat into the plate.
Inventables build images