DW660

From ShapeOko
Revision as of 09:11, 6 January 2013 by Winder (Talk | contribs)

Jump to: navigation, search

DW660

Overview

Created by: User:Improbable Construct

Upgrade Name: DW660

Description: Using the DW660 for your spindle

Status: Fully functional

Materials: 3/8" UHMW, HDPE, or ?

Details

DW660 Mounts

The drawings can be found on github


DW660 Modification


Tool Free Collar Removal and Spindle Lock Rotation
Use a T15 bit to remove the 4 screws holding the front of the tool together.

WARNING:
You have to hold the tool with the collet UP. If you don't, the entire rotor can fall out of the tool and requires total dis-assembly of the tool to re-install.

Once you have removed the 4 screws and the collet nut, the front of the tool comes right off. Remove the snap ring and the tool free collar comes off.
At this point you can also twist the black metal piece and yellow shroud 90 degrees to put the shaft lock on the side with the DeWALT logo.
Removal gives you more room under the tool and makes it much easier to use.
Use a 5/8" wrench to tighten the collet and the stock button to hold the shaft.

Discussion in the forum

Successful Implementations