Difference between revisions of "User:Willadams"

From ShapeOko
Jump to: navigation, search
(update after running cable management)
m (add picture)
Line 29: Line 29:
* run wiring --- DONE!
* run wiring --- DONE!
* make a nice enclosure of Lego bricks --- DONE (but see below)
* make a nice enclosure of Lego bricks --- DONE (but see below)
[[File:Wfa_shapeoko_ziptie_cable-mgmnt_mk-iii.JPG|thumb|none|400px|Current state]]
Remaining things to do:
Remaining things to do:

Revision as of 09:49, 20 May 2013

Got tired of seeing my name in red in the recent changes....

I'm a graphic designer who purchased a (used) ShapeOko w/ the intention of automating some woodworking projects and extending my capabilities, esp. hoping to build my own custom brass hardware (and tools) so as to not be limited to what's available for purchase commercially.

I'm an admin on the wiki here, so glad to help out w/ any edits or other issues.

(Otherwise) stock Shapeoko #364-R (rebuilt) w/ ¼″ drive shaft --- this was implemented using:

  • 1/4" pulley
  • 1/4" aluminum rod
  • 1/4" flanged bearing
  • HDPE bearing plate (the central hole on the plate has since been enlarged using a tapered reamer to 13/16" and the bearing now fits directly)
  • 5mm--1/4" coupler
  • 4 7/32" 1.5" roll pins (used as motor stand-offs)
  • 4 M3 screws 50mm long
  • an assortment of washers

Since implemented double MakerSlide X-Axis, Acme Screw Z-axis and 1m Y upgrades.

Additional things thus far:

  • drill new holes to rotate X and Y motors 45 degrees --- DONE!
  • drill new holes in X gantry plate for second pair of bolts --- decided to skip this, since not enough bolts which fit in the spacers.
  • drill new holes in X gantry plate to invert belt --- DONE!
  • use 10 1" spacers for carriage--gantry plate --- DONE! but they wouldn't fit over the nifty new bolts, so had to use pan head screws and only used 6 spacers and an assortment of washers
  • enlarge motor shaft hole in Y motor plate to accommodate moving pulley to outside --- DONE! Will test and see if it needs a thrust bearing or something.
  • use 1/4" music wire and 1 1/4" steel bar for Y-axis belt anchors --- DONE --- tried drawer guide instead of music wire --- didn't like it, but spare length of 1/4" aluminum rod worked,
  • use drawer guides for X-axis belt anchors --- DONE --- but a hole needs to be enlarged --- DONE
  • cut 3/16" tubing for motor mount spacers --- used a mix of 7/32" 1.5" roll pins and .5" aluminum spacers instead.
  • run wiring --- DONE!
  • make a nice enclosure of Lego bricks --- DONE (but see below)
Current state

Remaining things to do:

  • figure out how to invert belts on X-axis --- probably will do this by getting M5 pan head screws and grinding off the sides so that they fit snugly against the side of the motor.
  • make a nicer enclosure of Lego bricks --- need to hide away the wires for the p.s. and fan inside the enclosure --- add transparent bit for power LED, push through button for reset
  • dust collection
  • sound enclosure
  • work out management for Dremel power cord
  • upgrade spindle
  • replace remaining nylon spacers w/ metal
  • replace standard carriage plate w/ steel version